After understanding what wire drawing machines do, understand the type of small wire drawing machines.

Today, we are going to focus on what knowledge in the wire drawing machine? This is what we are curious about, so the following small series to answer, so that we know what to learn.

Today, Xiaobian will focus on the safety operation procedures of the small wire drawing machine, because after understanding what the wire drawing machine does, there is already a certain foundation, so in learning these knowledge contents, it should not be difficult for everyone to understand and master, but also to enhance the understanding of the wire drawing machine.

The main contents of the safe operation procedures for small wire drawing machines are:

(1) The various parts of the small wire drawing machine, as well as the fasteners and electrical parts, etc., to carry out the necessary inspection, mainly to see if there is any abnormal phenomenon, if there should be timely treatment.

(2) The equipment should be lubricated to maintain a good lubrication state and allow the equipment to operate normally.

(3) Before starting the equipment, check whether the rotation direction of the drum is correct and whether the clutch is sensitive and reliable.

(4) according to the requirements of the small wire drawing machine with mold operation, in the production process, after the production of the first piece to be inspected, whether it meets the requirements, through the inspection can continue production.

(5) When the small wire drawing machine is running, the operator should stand on both sides of the machine, not on the front and rear positions of the machine to prevent the material from being unhooked and hurting people.

(6) After pulling a plate of material, it is safer to disengage the clutch in time and wait until the material is naturally relaxed before taking the material from the drum.

(7) wire drawing machine in the process of drawing, if the material on the discharge plate knot phenomenon, then should immediately stop for processing, it is strictly prohibited to drive processing, this is very dangerous.

(8) After the work is completed, cut off the power supply of the equipment, clean and sort out the operation site, fill in the operation records, and do a good job of shift change.