How to calculate the problem and working speed of water tank wire drawing machine?

Drawing machine, drawing machine for this, because it is a machine for drawing parts, for the following small series is introduced, and then explained, so the following content or associated with it. Specifically, it is the first to answer his question, and then back to explain how the calculation of the running speed of the traction head allows more understanding of this drawing machine this year, and may rise in the amount of knowledge.

Q: What are the requirements of the water tank wire drawing machine? And what is the reason for the black silk and white silk as a painting process?

Some responses to this question are:

In the water tank drawing machine, the most basic requirement is to handle the work, but no pollution or pollution, to achieve this long line. For the above problems, the reason is the problem caused by the main lack of compressive strength of the drawing liquid and the suction liquid.

The stretched cans of each operating speed stretching machine are calculated as follows:

PD2V1 2V2 =μD

Among them:

π: Pi.

D: Line diameter.

V1: Line speed.

D: Diameter wire socket.

V2: Line speed line that meets the conditions.

By this formula, you can get the running speed of the tractor head.

The wire drawing machine, no matter what kind of specification model, or what kind, as well as the basic and necessary functions are the same, is the key to the quality and effect of the drawing equipment. So, we should learn better and faster how to do? The following small series to give you a clear answer, I hope to give you some specific knowledge useful content.

How to quickly and effectively draw what we can do is:

(1) try to use a relatively large heavy pot, and good quality raw materials.

(2) Graphics should be prepared in subsequent processing, paying special attention to the quality of the surface of the material.

(3) Discharge the pipeline and take-up the way it used to be appropriate to avoid problems such as garbled or broken wire, and also to match the wire drawing speed of the operation.

(4) Use appropriate oil and suitable processing conditions.

(5) Surface quality, lubrication, cooling, mold and material properties, etc., should be considered as the influence of the drawing process.

(6) Under the premise of controlling the operating temperature and ensuring the surface quality, the equipment should be fully utilized without waste.